Closed cooling tower type CFR-C-TG

Almeco CFR-C-TG is a closed cooling tower with a tube bundle and a centrifugal forced draught fan.

A closed cooling tower, or cooling tower with closed cooling circuit type Almeco CFR-C-TG, is mainly used when the water to be cooled, or mixture of water/glycol, must not come into contact with contaminations from the ambient air and where the noise level and/or the height of the cooling tower must be limited.

The water to be cooled flows through a closed tube bundle. By spraying evaporation water on the outside of the tube bundle and blowing dry air over the heat exchanger, evaporation cooling is achieved. This allows the water or the water/glycol mixture to cool below ambient temperature.

Closed cooling tower type CFR-C-TG, Almeco
Closed cooling tower type CFR-C-TG, Almeco

General

  • The CFR-C-TG cooling tower is made in accordance with the strictest legionella legislation.
  • Both the individual components and the cooling tower as a whole comply with the Best Available Technology (BAT).
  • Each fan is driven by a separate motor.
  • The entire self-supporting casing and water basin are made of fibreglass-reinforced polyester.
  • The support structure for the casing and the drive is made of hot-dip galvanised steel.
  • The highly efficient tube bundle (heat exchanger) is made of hot-dip galvanised steel.
  • All models of this type are supplied in one piece, including circulation pump and intermediate pipes for the evaporation water.

Advantages

  • Easy to install (full pre-assembly in factory)
    *For transport, the silencers on the outlet section of Low Noise models are delivered separately.
  • Low operation cost
  • Long, rust-free service life
  • Energy efficient motor for fan and pump (IE3)
  • Easy access for safe control and maintenance
  • Highly efficient drift separator in accordance with the applicable legionella regulations
  • Cooling tower suitable for cooling water up to a maximum of 80°C

Options

  • Full control with monitoring and management
  • Silencers on the air inlet and outlet side
  • Tube bundle in stainless steel
  • …

Dimension drawings

CFR-C-2121-TG

  1. Cooled water outlet
  2. Drain cooling tower
  3. Overflow
  4. Make up water valve
  5. Cooling tower frame hot-dip galvanised
  6. Stainless steel inspection doors
  7. Water to be cooled inlet
  8. Belt protection
Dimension drawing of CFR-C-2121-TG, Almeco

CFR-C-2121-TG-LN

  1. Cooled water outlet
  2. Drain cooling tower
  3. Overflow
  4. Make up water valve
  5. Cooling tower frame hot-dip galvanised
  6. Stainless steel inspection doors
  7. Water to be cooled inlet
  8. Drift separator inspection hatch
  9. Air inlet silencer
  10. Air outlet silencer
Dimension drawing of CFR-C-2121-TG-LN, Almeco